|
View: Grid | List
Sort by: popularity |
lowest price |
highest price
|
|
Ideal for budget conscious boaters. Designed to Mayfair's exacting standards with many of the same features of more expensive pumps. Manufactured in the U.S.A. 400 GPH, 3/4" Hose size, 12 Volt, Max amp draw 2.0, 3-7/8" high.
Starting At: $11.58
…pump offers impressive pumping power for its size and cost. Most competitive models in this pumping range are much larger and far more expensive. 12 Volts DC unless noted. 1100 GPH automatic. Float switches are not required for these fully automatic pumps. Controlled by computerised operation, the pump…
Starting At: $81.01
The Original Interchangeable Cartridge Pump. Easy to Install and Service. The Pumps Motor Cartridge Can Be Removed, Cleaned, Replaced or Upgraded to a Higher Capacity in Just Minutes. The Float Switch Has a Built In Manual Test Tab for Easy Operational System Test. Saltwater Tough, Made in the USA and…
Starting At: $63.
This pump features a high pumping capacity and reliability at a lower cost. The Rule 1500 offers more pumping capacity and more exclusive design features than any comparable competitive pump. 1-1/8" (28.6mm) discharge outlet. 12 Volts DC unless noted.
Starting At: $67.83
Drill Pump. Jabsco drill pumps provide a very versatile means of transfering fluid almost anywhere an electric drill can be operated. They provide easy powered pumping anywhere a hand utility pump might be used.
Starting At: $19.26
…float rises, the pump turns on. There is no on/off cycling and therefore, no power use until the pump comes on. The pump remains on until the float drops and the pump senses no load against the impeller. Thoughtfully designed, Rule-Mate pumps can be used in practically all bilge pumping applications.
Starting At: $64.56
…float rises, the pump turns on. There is no on/off cycling and therefore, no power use until the pump comes on. The pump remains on until the float drops and the pump senses no load against the impeller. Thoughtfully designed, Rule-Mate pumps can be used in practically all bilge pumping applications.
Starting At: $152.89
…float rises, the pump turns on. There is no on/off cycling and therefore, no power use until the pump comes on. The pump remains on until the float drops and the pump senses no load against the impeller. Thoughtfully designed, Rule-Mate pumps can be used in practically all bilge pumping applications.
Starting At: $84.09
…(3028 lph) pump in a round version. This pump features many mounting variations as well as a gas resistant strainer base. 3/4" (19mm) discharge outlet. 12 Volts DC unless noted. Float switches are not required for these fully automatic pumps. Controlled by computerised operation, the pump will turn on…
Starting At: $65.90
…popular on smaller craft, Rule 500 pumps are unmatched in pumping power and longevity. Automatic. 3/4'' (19mm) discharge outlet. 12 Volts DC unless noted. Float switches are not required for these fully automatic pumps. Controlled by computerised operation, the pump will turn on every 2.5 minutes for…
Starting At: $53.32
This submersible pump is a great way to remove unwanted water from boats, pool covers, aquariums and sump pits. Convenient and safe, too, because it needs no electrical cord runs up to 5 hours on three alkaline D batteries. Measures 6-3/8" high x 5-1/4" diameter. Able to pump up to 200 gallons per hour…
Starting At: $30.92
The Johnson Pump Macerator pump takes care of the toilet waste, shredding it before it is pumped into or out from the holding tank. CE-approved Features Ignition protected motor, conforming with ISO 8846 Marine Mounting bracket for easy replacement Extremely energy efficient Rotary cutter casing of…
Starting At: $98.99
This pump offers impressive pumping power for its size and cost. Most competitive models in this pumping range are much larger and far more expensive. 12 Volts DC unless noted. 1100 GPH.
Starting At: $35.93
The Rule 500 offers many design features while keeping size and cost to a minimum. Especially popular on smaller craft, Rule 500 pumps are unmatched in pumping power and longevity. Equipped with a cartridge motor. 3/4'' (19mm) discharge outlet. 12 Volts DC unless noted.
Starting At: $24.15
Boaters, boat-builders and dealers all want one thing from their bilge pumps more power! And that's what the Tsunami Series delivers... with high-capacity, high-efficiency output. Tsunami Cartridge pumps have replaceable / interchangeable motor cores. Makes servicing simple and quick. Backed by Attwood's…
Starting At: $13.64
These pumps fill a typical 40 gallon ballast tank in under 5 minutes. Pump is reversible to both fill and empty tank. With exclusive Run - dry protection the pump shuts off before the impeller is damaged. Equipped with 1-2" NPT internal port and 1" external hose barb. Measures 7 1-8" x 4 3-4" x 3 5…
Starting At: $182.10
|